DEVI DEVIreg 535 Guide d'installation

DEVIreg™ 535Electronic ThermostatInstallation Guidewww.DEVI.com

The screen of the heating cable must be connected tothe earth conductor of the power supply cable by us-ing a separate connector.Note: Always instal

3 SettingsSensor: How to specify whether an external floor sen-sor, the built-in room sensor or both is used to controlthe floor heatingNote: The floo

If both a room sensor and a floor sen-sor is used, choose:This option is suitable for all roomsbut wet rooms. The thermostat mustbe installed in the

How to set the maximum floor temperatureSpecial condition: This setting only applies if a floor sensoris used (the floor sensor or room/floor sensor o

Note: Please contact the floor supplier before changing themaximum floor temperature and be aware of the following:▪The floor temperature is measured

How to define the temperature scaleSpecial condition: If floor sensor is selected, the numericalscale with steps from 1 - 6 must be selected.Note: By

5 Disposal InstructionDEVIreg™ 53516 Installation Guide

DEVIreg™ 535Installation Guide 17

DEVIreg™ 53518 Installation Guide

DEVIreg™ 535Danfoss A/SElectric Heating SystemsUlvehavevej 617100 VejleDenmarkPhone: +45 7488 8500Fax: +45 7488 8501E-mail: [email protected]

The English language is used for the original instructions.Other languages are a translation of the original instructions.(Directive 2006/42/EC)

DEVIREG 535 ELKO140F1050Timer ThermostatFloor/Room Sensor220-240V~50-60Hz~+5 to +45°C15A/3450W@230V~IP 31Product DocumentationNO EL 5402665FI SSTL 353

Table of Contents1 Introduction ... 31.1 Technical Specifications ... 41.2 Safety Instructions ... 62 Mounting Instructions ...

The thermostat has buttons for adjusting the temperaturesetting, and a LED indicator showing standby periods(green light) and heating periods (red lig

Temperature range 5-35°C with room sensor5-45°C with floor sensor onlyFloor max 20-50°CFloor min 10-35°C, when instal-led with combination of roomand

1.2 Safety InstructionsMake sure the mains supply to the thermostat is turned offbefore installation.IMPORTANT: When the thermostat is used to control

2 Mounting InstructionsPlease observe the following placement guidelines:Place the thermostat at a suitable heighton the wall (typically 80-170cm.).Th

Do not place the thermostat in a way thatit will be exposed to direct sunlight.Note: A floor sensor enables a more accu-rate temperature control and i

Follow the steps below to mount the thermostat:1. Open the thermostat: devireg™550devireg™550D▪Gently press the release tab in the bottom of thethermo